Galil DMC-1700 Manual De Usuario

  

When configured for stepper motor operation, several commands are interpreted differently than from servo mode.  
The following describes operation with stepper motors. 

In order to command stepper motor operation, the appropriate stepper mode jumpers must be installed.  See chapter 
2 for this installation. 

Stepper motor operation is specified by the command MT.  The argument for MT is as follows: 

 2   specifies a stepper motor with active low step output pulses 
-2  specifies a stepper motor with active high step output pulses 
 2.5specifies a stepper motor with active low step output pulses and reversed direction 
-2.5 specifies a stepper motor with active high step output pulse and reversed direction 

The command, KS, provides stepper motor smoothing.  The effect of the smoothing can be thought of as a simple 
Resistor-Capacitor (single pole) filter.  The filter occurs after the motion profiler and has the effect of smoothing out 
the spacing of pulses for a more smooth operation of the stepper motor.  Use of KS is most applicable when 
operating in full step or half step operation.  KS will cause the step pulses to be delayed in accordance with the time 
constant specified. 

When operating with stepper motors, you will always have some amount of stepper motor smoothing, KS.  Since 
this filtering effect occurs after the profiler, the profiler may be ready for additional moves before all of the step 
pulses have gone through the filter.  It is important to consider this effect since steps may be lost if the controller is 
commanded to generate an additional move before the previous move has been completed.  See the discussion 
below, Monitoring Generated Pulses vs Commanded Pulses. 

The general motion smoothing command, IT, can also be used.  The purpose of the command, IT, is to smooth out 
the motion profile and decrease ‘jerk’ due to acceleration.  

For proper controller operation, it is necessary to make sure that the controller has completed generating all step 
pulses before making additional moves.  This is most particularly important if you are moving back and forth.  For 
example, when operating with servo motors, the trippoint AM (After Motion) is used to determine when the motion 
profiler is complete and is prepared to execute a new motion command.  However when operating in stepper mode, 
the controller may still be generating step pulses when the motion profiler is complete.  This is caused by the stepper 
motor smoothing filter, KS.  To understand this, consider the steps the controller executes to generate step pulses: 

First, the controller generates a motion profile in accordance with the motion commands.   

Second, the profiler generates pulses as prescribed by the motion profile.  The pulses that are generated by the 
motion profiler can be monitored by the command, RP (Reference Position).  RP gives the absolute value of the 
position as determined by the motion profiler.  The command, DP, can be used to set the value of the reference 
position.  For example, DP 0, defines the reference position of the X axis to be zero. 

Third, the output of the motion profiler is filtered by the stepper smoothing filter.  This filter adds a delay in the 
output of the stepper motor pulses.  The amount of delay depends on the parameter which is specified by the 
command, KS.  As mentioned earlier, there will always be some amount of stepper motor smoothing.  The default 
value for KS is 2 which corresponds to a time constant of 6 sample periods. 

Fourth, the output of the stepper smoothing filter is buffered and is available for input to the stepper motor driver.  
The pulses which are generated by the smoothing filter can be monitored by the command, TD (Tell Dual).  TD 
gives the absolute value of the position as determined by actual output of the buffer.  The command, DP sets the