Schneider Electric PM5300 Manual De Usuario

42

© 2014 Schneider Electric All Rights Reserved

Chapter 4—Front panel display and meter setup

PowerLogic™  PM5300 series user guide

3. Navigate to Meter > Advan.

4. Move the cursor to point to the parameter you want to modify, then press Edit.

5. Modify the parameter as required, then press OK.

6. Move the cursor to point to the next parameter you want to modify, press Edit, 

make your changes, then press OK.

7. Press Yes to save your changes.

•

See“Total Harmonic Distortion and Total Demand Distortion” on page 89 for details 
on how the meter calculates TDD.

The LED setup screen allows you to configure the alarm / energy pulsing LED for 
alarming or energy pulsing application.

1. Navigate to Maint > Setup.

2. Enter the setup password (default is “0000”), then press OK.

3. Navigate to I/O > LED.

4. Press Edit.

5. Press   or   to modify the parameter as required, then press OK.

6. Press   to exit. Press Yes to save your changes.

Label

-----

This label identifies the device, e.g., “Power 
Meter”. You cannot use the front panel to edit 
this parameter. Use ION Setup to change the 
device label.

Load Timer Setpt (A)

0 - 99999

Specifies the minimum average current at the 
load before the timer starts. The meter begins 
counting the operating time whenever the 
readings are equal to or above this average 
current threshold.

Pk I dmd for TDD (A)

0 - 99999

Specifies the minimum peak current demand 
at the load for inclusion in total demand 
distortion (TDD) calculations. If the load 
current is below the minimum peak current 
demand threshold, the meter does not use the 
readings to calculate TDD. Set this to “0” 
(zero) if you want the power meter to use the 
metered peak current demand for this 
calculation.

Mode

Off, Alarm, Energy

Off disables the LED.
Alarm sets the LED for alarm notification.
Energy sets the LED for energy pulsing.

Maint

Reset

Setup

Meter

Comm

Alarm

HMI

Clock

LED

Relay

I/O

D Out

S In