Schneider Electric PM5300 Manual De Usuario

PowerLogic™  PM5300 series user guide 

Chapter 6—Input / Output

© 2014 Schneider Electric All Rights Reserved

51

You can use the front panel to configure the status inputs.

1. Navigate to Maint > Setup.

2. Enter the setup password (default is “0”), then press OK.

3. Navigate to I/O > S In.

4. Move the cursor to point to the status input you want to set up, then press Edit.

5. Move the cursor to point to the parameter you want to modify, then press Edit.

If Edit is not displayed, it means the parameter is either read-only or can 

only be modified through software. 

6. Modify the parameter as required, then press OK.

7. Move the cursor to point to the next parameter you want to modify, press Edit, 

make your changes, then press OK.

8. Press   to exit. Press Yes to save your changes.

See “Technical Specifications” on page 15 for electrical characteristics and limits for the 
status inputs.

Label

—

This can be modified only through software. Use this 
field to assign names to the status inputs (S1 and S2).

Debounce Time 
(ms)

0 to 1000

Debounce is the time delay that compensates for 
mechanical contact bounce. Use this field to set how 
long (in milliseconds) the external signal must remain in 
a certain state to be considered a valid state change.

Control Mode

Normal

This field displays how the status input functions.
Normal: the status input is not associated with another 
meter function. The meter counts and records the 
number of incoming pulses normally.

Maint

Reset

Setup

Meter

Comm

Alarm

HMI

Clock

LED

Relay

I/O

D Out

S In