Metrologic Instruments MS1690 Focus Manuel D’Utilisation

 

 

8 

I

NSTALLING THE 

S

CANNER TO THE 

H

OST 

S

YSTEM

 

 

1.  Turn off the host device. 

 

2.  Plug the 10-pin RJ45 male end of the 

PowerLink cable into 10-pin socket on 
the scanner.  There will be an audible 
click when the connector lock engages. 

 

3.  Disconnect the keyboard from the host 

device. 

 

4.  Connect the “Y” ends of the 

communication cable to the keyboard 
and keyboard port on the host device. 
If necessary use the male/female 
adapter cable supplied with the scanner 
for proper connections. 

 

5.  Plug the external power supply (required) 

into the power jack on the PowerLink cable. 

 

Check the AC input requirements 
of the power supply to verify the 
voltage matches the AC outlet.  The 
outlet must be located near the 
equipment and be easily accessible. 

6.  Connect AC power to the transformer. 

 

7.  The scanner will start to initialize.  All LEDs (yellow, white, and blue) will light 

for approximately two seconds then start to alternately flash.  When the 
scanner has finished initializing the LEDs will stop flashing and the unit will 
beep three times indicating that the scanner is ready for use.  

 

8.  Turn on the host device. 

 

Plugging the scanner into a port on the host system does not guarantee that 
scanned information will be communicated properly to the host system.  The 
scanner is shipped from the factory configured with default settings.  Please 
refer to the MetroSelect Single-Line Configuration Guide (

MLPN 

00-02544) or 

MetroSet2’s help files for instructions on changing the scanner’s 
configuration.  In addition, please check that the scanner and host system 
are using the same communication protocol.