Emerson MODBUS IP Manuel D’Utilisation

DC Bus Current 

The current at the battery input terminals. In charging mode, the 

current will be a positive value. In discharging mode, the current will 

be a negative value 

Frame Capacity 

Total system capacity supported when the maximum number of 

power modules are installed. 

Frame Fan Fault 

The frame top outlet fan has failed. 

Inverter On/Off State 

inverter on/off state 

Inverter Shutdown - Overload 

The inverter has shutdown due to a sustained overload 

Inverter Status 

Status of the inverter output. Active means the inverter is online with 

regulated output voltage and ready to power the load. Inactive 

means the inverter is offline and not ready to power the load.

Loss of Redundancy 

The system has an insufficient number of power modules to provide 

redundancy. 

Low Battery - Shutdown Imminent 

If active and guaranteed shutdown is enabled, a low battery reserve 

condition exists that will shutdown the UPS. 

Low Battery Warning Time 

When battery time remaining falls to, or below, this value the low 

battery alarm is activated. 

Manual Battery Test 

Command to initiate a manual battery test. 

Maximum Load Alarm Limit 

Maximum load [VA] supportable without a 'Maximum Load Alarm' 

condition. 

Maximum Load Alarm 

Maximum load alarm indicating load setting has been exceeded. 

Module Operating Status 

The operating status for this Battery Module. 

Module Operating Status 

The operating status for this Bypass Control Module. 

Module Operating Status 

The operating status for this Charger Module. 

Module Operating Status 

The operating status for this Power Module. 

No Load Warning Current Threshold 

If the output current is below this number of amps for a period of [No 

Load Warning Delay] time, the [No Load Warning] will become 

active. 

No Load Warning Delay 

If the output current is below the [No Load Warning Current 

Threshold] number of amps for this period of time, the [No Load 

Warning] will become active. 

No Load Warning 

Indicates the UPS has output voltage but the output current is below 

a set threshold [No Load Warning Current Threshold] for a set period 

of time [No Load Warning Delay]. 

Number of Active Battery Strings 

The total number of active battery strings. 

Number Of Active Power Modules 

The total number of active power modules. 

Number of Battery Strings With Warnings 

The total number of battery strings with warnings. 

Number of Discharge Cycles 

The highest number of battery discharge cycles among all installed 

Battery Modules. 

Number of Discharge Cycles 

The total number of battery discharge cycles for the Battery Module 

since it was made. 

Number of EBC Installed 

The total number of Extended Battery Cabinets installed. 

Number of Failed Battery Strings 

The total number of failed battery strings. 

Number Of Failed Power Modules 

The total number of failed power modules. 

Number of Installed Battery Strings 

The total number of battery strings installed. 

Number of Installed Power Modules 

The total number of Power Modules installed. 

Number Of Power Modules With Warnings 

The total number of power modules with warnings. 

Number Of Transfers To Bypass 

The total number of transfers to bypass from inverter since system 

startup.