3com WX3000 Manuel D’Utilisation

 

1-11 

Follow these steps to enable the display of system information on a monitor terminal: 

Enable the debugging/log/trap 
information terminal display 
function 

Optional 

Enabled by default 

Enable debugging information 
terminal display function 

Optional 

Disabled by default 

Enable log information terminal 
display function  

Optional 

Enabled by default 

Enable trap information 
terminal display function  

Optional 

Enabled by default 

 

Make sure that the debugging/log/trap information terminal display function is enabled (use the 

terminal monitor command) before you enable the corresponding terminal display function by using 

the terminal debugging, terminal logging, or terminal trapping command. 

 

Follow these steps to set to output system information to a log host: 

Enter system view 

— 

Enable the information center 

info-center enable 

Optional 

Enabled by default. 

Enable system information 
output to a log host 

info-center loghost 
host-ip-addr [ channel 
{ channel-number | 
channel-name } | facility 
local-number ]* 

Required 

By default, the device does not 
output information to the log 
host. 

After you configure the device 
to output information to the log 
host, the device uses 
information channel 2 by 
default. 

Configure the source interface 
through which log information is 
sent to the log host 

info-center loghost source 
interface-type interface-number

Optional 

By default, no source interface 
is configured, and the system 
automatically selects an 
interface as the source 
interface. 

Configure the output rules of 
system information 

info-center source 
{ modu-name | default } 
channel { channel-number | 
channel-name } [ { log | trap | 
debug } { level severity | state 
state } ]* 

Optional 

Refer to 

default output rules of system 
information.