3com S7906E Guide De Référence

 

1-43 

IPv6 PIM view 

2: System level 

acl6-number: Basic or advanced IPv6 ACL number, in the range of 2000 to 3999. 

Use the source-policy command to configure an IPv6 multicast data filter.  

Use the undo source-policy command to remove the configured IPv6 multicast data filter.  

By default, no IPv6 multicast data filter is configured.  

Note that:  

z 

If you specify a basic ACL, the device filters all the received IPv6 multicast packets based on the 

source address, and discards packets that fail the source address match.  

z 

If you specify an advanced ACL, the device filters all the received IPv6 multicast packets based on 

the source and group addresses, and discards packets that fail the match.  

z 

If this command is executed repeatedly, the last configuration will take effect.  

# Configure the router to accept IPv6 multicast packets originated from 3121::1 and discard IPv6 

multicast packets originated from 3121::2.  

<Sysname> system-view 

[Sysname] acl ipv6 number 2000 

[Sysname-acl6-basic-2000] rule permit source 3121::1 128 

[Sysname-acl6-basic-2000] rule deny source 3121::2 128 

[Sysname-acl6-basic-2000] quit 

[Sysname] pim ipv6 

[Sysname-pim6] source-policy 2000 

[Sysname-pim6] quit 

spt-switch-threshold infinity [ group-policy acl6-number [ order order-value ] ] 

undo spt-switch-threshold [ group-policy acl6-number ] 

IPv6 PIM view 

2: System level