3com S7906E Guide De Référence

 

1-22 

Note that: 

z 

The source-ip ipv6-source-address option in the command is meaningful only for MLD Snooping 

version 2. If MLD Snooping version 1 is running, although you can include source-ip 

ipv6-source-address in your command, the simulated host responses with only an MLDv1 report 

when receiving a query message.  

z 

If configured in Ethernet interface view or Layer 2 aggregate interface view, this feature takes effect 

only if the interface belongs to the specified VLAN. 

z 

If configured in port group view, this feature takes effect only on those ports in this port group that 

belong to the specified VLAN.  

# Configure Ethernet 2/0/1 in VLAN 2 to be a static member port for (2002::22, FF3E::101).  

<Sysname> system-view 

[Sysname] mld-snooping 

[Sysname-mld-snooping] quit 

[Sysname] vlan 2 

[Sysname-vlan2] mld-snooping enable 

[Sysname-vlan2] mld-snooping version 2 

[Sysname-vlan2] quit 

[Sysname] interface ethernet 2/0/1 

[Sysname-Ethernet2/0/1] mld-snooping static-group ff3e::101 source-ip 2002::22 vlan 2 

mld-snooping static-router-port vlan vlan-id 

undo mld-snooping static-router-port vlan vlan-id 

Ethernet interface view, Layer 2 aggregate interface view, port group view 

2: System level 

vlan vlan-id: Specifies a VLAN in which one or more static router ports are to be configured, where 

vlan-id is in the range of 1 to 4094.  

Use the mld-snooping static-router-port command to configure the current port(s) as static router 

port(s).  

Use the undo mld-snooping static-router-port command to restore the system default.  

By default, no ports are static router ports.  

Note that: 

z 

This command works on both MLD Snooping–enabled VLANs and VLANs with MLD enabled on 

their VLAN interfaces.