3com S7906E Guide De Référence

 

1-21 

ipv6-address: Specifies an IPv6 link-local address as the source IPv6 address of MLD 

multicast-address-specific queries.  

Use the mld-snooping special-query source-ip command to configure the source IPv6 address of 

MLD multicast-address-specific queries.  

Use the undo mld-snooping special-query source-ip command to restore the default configuration.  

By default, the source IPv6 address of MLD multicast-address-specific queries is 

FE80::02FF:FFFF:FE00:0001. 

This command takes effect only if MLD Snooping is enabled in the VLAN.  

# In VLAN 2, specify FE80:0:0:1::1 as the source IPv6 address of MLD multicast-address-specific 

queries.  

<Sysname> system-view 

[Sysname] vlan 2 

[Sysname-vlan2] mld-snooping special-query source-ip fe80:0:0:1::1 

mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id 

undo mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id 

Ethernet interface view, Layer 2 aggregate interface view, port group view 

2: System level 

ipv6-group-address: Address of a IPv6 multicast group the port(s) will be configured to join as static 

member port(s). The effective range is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), 

where x and y represent any hexadecimal number between 0 and F, inclusive.  

ipv6-source-address: Address of the IPv6 multicast source the port(s) will be configured to join as static 

member port(s).  

vlan vlan-id: Specifies the VLAN that comprises the Ethernet port(s), where vlan-id is in the range of 1 

to 4094.  

Use the mld-snooping static-group command to configure the static IPv6 (*, G) or (S, G) joining 

function, namely to configure the port or port group as static IPv6 multicast group or source-group 

member(s).  

Use the undo mld-snooping static-group command to restore the system default.  

By default, no ports are static member ports.