AeroScout FM Manuel D’Utilisation
Hardware Features
M310 Fall Monitor – Setup & User Guide 5
Wheelchair Mounting Clips
Use the small metal clip to attach the
monitor to surfaces up to
monitor to surfaces up to
5
/
16
” thick (e.g., the
back of a wheelchair).
Use the large wire clip to attach the monitor
to surfaces
Use the large wire clip to attach the monitor
to surfaces
5
/
16
” to 2¼” thick (e.g., the
headboard of a bed).
For more information, see “Monitor Mounting/Installation Options” on
page 14.
For more information, see “Monitor Mounting/Installation Options” on
page 14.
Wall Mounting Bracket
Use the supplied plastic wall mounting bracket to attach the monitor
to a wall with the built-in guide rails.
to a wall with the built-in guide rails.
Battery Cover
The battery cover is used to protect the batteries
and the settings area (alert volume, tones, etc.)
Check that the battery cover retention screw is
tightened to avoid batteries accidentally falling
out if the monitor is dropped, and to reduce the
possibility of battery theft.
For more information, see “Replacing Monitor
Batteries” on page 10.
and the settings area (alert volume, tones, etc.)
Check that the battery cover retention screw is
tightened to avoid batteries accidentally falling
out if the monitor is dropped, and to reduce the
possibility of battery theft.
For more information, see “Replacing Monitor
Batteries” on page 10.
Settings
Behind the battery cover, there are buttons and
switches used to control audible alert selection,
volume, and alert delay times.
The play and record buttons, and the microphone
are used to record custom audible pre-alerts
messages of up to 15 seconds duration, after
which the alarm sounds. The hole to the right
of the buttons allows visibility for the LED which
indicates recording in progress.
DIP switch 1 is used to enable/disable audible
alerts. DIP switch 2 is used to select between “Normally Open” and
“Normally Closed” Nurse Call systems. DIP switch 3 is not in use.
switches used to control audible alert selection,
volume, and alert delay times.
The play and record buttons, and the microphone
are used to record custom audible pre-alerts
messages of up to 15 seconds duration, after
which the alarm sounds. The hole to the right
of the buttons allows visibility for the LED which
indicates recording in progress.
DIP switch 1 is used to enable/disable audible
alerts. DIP switch 2 is used to select between “Normally Open” and
“Normally Closed” Nurse Call systems. DIP switch 3 is not in use.