AeroScout FM Manuel D’Utilisation
Hardware Features
6
M310 Fall Monitor – Setup & User Guide
Power Supply Connector
This is used to connect a 5V power supply.
Nurse Call Cable Connector
This is used to connect a Nurse Call cable.
Sensormat Pad Connectors
These are used to connect 1 or 2 Sensormat pads.
Additional Features
The monitor includes a latex-free rubber bumper around the perimeter
to protect the monitor damage by dropping.
to protect the monitor damage by dropping.
Alerts and Status Indicators
LED use during normal conditions is minimized to help extend the
monitor’s battery life. State changes are triggered by incoming events
such as a press on the monitor’s Reset button, a change to the Nurse
monitor’s battery life. State changes are triggered by incoming events
such as a press on the monitor’s Reset button, a change to the Nurse
Call jack (plugged or unplugged), low battery condition, etc.
LED alerts are displayed via the Reset button and the status indicator
LEDs.
LED alerts are displayed via the Reset button and the status indicator
LEDs.
Reset Button Red LED
The Reset button flashes red to indicate that an
unexpected pad exit has occurred. The alarm LED is easily
seen from a distance of 4 meters in normal facility lighting
conditions unless direct sunlight is falling on the monitor.
unexpected pad exit has occurred. The alarm LED is easily
seen from a distance of 4 meters in normal facility lighting
conditions unless direct sunlight is falling on the monitor.
Reset Button Green LED
The Reset button flashes green while it is being armed,
when it is in Hold mode, and once when an alarm is
canceled.
when it is in Hold mode, and once when an alarm is
canceled.