AeroScout FM Manuel D’Utilisation
Monitor Setup
M310 Fall Monitor – Setup & User Guide 9
3.
A red LED will flash while the button is depressed. This
indicates that the device is recording.
indicates that the device is recording.
4.
Speak in a clear voice towards the microphone opening
(located at the bottom left of the monitor back) and release the
microphone button when finished.
(located at the bottom left of the monitor back) and release the
microphone button when finished.
The red LED will stop flashing.
5.
Press the button beside the Play icon to hear the recorded alert.
With the right settings, the recorded message will play before
the Bed Exit Alarm.
the Bed Exit Alarm.
Note:
Custom audible alerts can be recorded while a Sensormat
pad is connected to the monitor, but they CANNOT
be recorded while a patient/resident is being actively
monitored.
pad is connected to the monitor, but they CANNOT
be recorded while a patient/resident is being actively
monitored.
Note:
Recorded message length can be up to 15sec. Following
15sec of message recording a positive beep will sound to
indicate the recording time is over.
15sec of message recording a positive beep will sound to
indicate the recording time is over.
DIP Switch Functions
1A
Don’t play the recorded message in case of alarm
1B
Play the recorded message in case of alarm
2A
“Normally Open” wired Nurse Call system
2B
“Normally Closed” wired Nurse Call system
Hold Mode
Hold Mode is used to allow the caregiver 2 minutes to remove a
patient/resident from a monitored pad without triggering any alarms.
patient/resident from a monitored pad without triggering any alarms.
1.
While the patient/resident is being monitored on the pad, press
and hold the Reset button on the monitor for 3 seconds or
longer.
and hold the Reset button on the monitor for 3 seconds or
longer.
2.
A 2-minute timer is set. The patient/resident can now be
removed from the pad without triggering an alarm.
removed from the pad without triggering an alarm.
3.
The reset button flashes green once per second for 115 seconds,
then flashes rapidly for the final 5 seconds, at which point a
confirmation tone sounds to indicate that Hold Mode is over.
then flashes rapidly for the final 5 seconds, at which point a
confirmation tone sounds to indicate that Hold Mode is over.