SendFar Technology Co. Ltd. OAB-03001 Manuel D’Utilisation

3.4 Wireless Client Router-to-Central Wireless
Router

3.3 Wireless Access Bridge-to-Central Wireless
Router

1. Set the Central RB run as a Wireless Router (Wireless Interface IP is

192.168.1.1, Ethernet Interface IP is 192.168.2.1, default route is
192.168.2.254).

1. Set the Central RB run as a Wireless Router (Wireless Interface IP is

192.168.1.1, Ethernet Interface IP is 192.168.2.1, must turn on NAT on
Ethernet interface, default route is 192.168.2.254).

2. Set Wireless parameters on Central RB: Channel (1) and SSID

(wireless).

2. Set Wireless parameters on Central RB: Channel (1) and SSID

(wireless)

3. Set the Remote RB as a Wireless Router (Wireless Interface IP is

192.168.1.2, Ethernet Interface IP is 192.168.10.1, default route is
192.168.1.1).

3. Set the DHCP server service on the Central RB and apply it on

Wireless Interface.

4. Set Wireless parameters on Remote RB: Channel (1) and SSID

(wireless), these parameters must same with Central RB.

4. Set the Remote RB as a Bridge (Bridge Interface IP is 192.168.1.2).
5. Set Wireless parameters on Remote RB: Channel (1) and SSID

(wireless), these parameters must same with Central RB.

5. Set the DHCP server service on the Remote RB and apply it on

Ethernet Interface.

6. The Central RB assign IP address to PC1 and PC2

6. The Remote RB assigns IP address to PC1 and PC2.

7. The operator can also turn off NAT behavior on Central RB and

two subnets are transparent.

The operator can also turn off NAT behavior on Central RB and turn
on NAT behavior on Remote RB. In this case, any outgoing packets
will transfer to 192.168.1.2.

Remote RB: turn on NAT on Wireless Interface.

The operator can also turn on NAT behavior on Central RB and turn
on NAT behavior on Remote RB.

Central RB: turn on NAT on Ethernet interface.

Remote RB: turn on NAT on Wireless Interface.

Version 1.00