Tyco Safety Products/Sensormatic AMS9050 Manuel D’Utilisation

Preliminary 

Connect the following cables to the AMS-9050 
controller. Refer to Figure 1and Figure 2. 

 

(Ant A Alarms) 

0652-0243-01 (AMS-9050 Com) 
from P5 on Antenna A 

 

(Ant A Tx) 

0652-0467-02 (AMC-7000 Tx/Rx) 
from P1 on AMC-7000 

 

(Ant B/D Alarms) 

0652-0468-01 (AMC-7000 Power) 
from P8 on AMC-7000 

 

(Remote Alarm) 

0652-0468-01 (AMC-7000 Power) 
from P14 on AMC-7000 

Wired Sync 

0652-0467-01 (AMC-7000 Wired 
Sync) from P5 on AMC-7000 

P88 
Ant C Tx 

0652-0467-02 (AMC-7000 Tx/Rx) 
from P3 on AMC-7000 

P93 
Ant C Alarms 

0652-0243-01 (AMS-9050 Com) 
from P5 on Antenna C 

1  The eight-pin Alarm/comm connector is supplied to connect 

the AMC-7000 Power and AMC-7000 Com cables to P97 or 
P100 on the AMS-9050. The AMS-9050 controller should 
already have this connector, so this connector should not be 
needed.  

2  Use one of the two five-pin Aux/Wired Sync connectors to 

connect the wired sync cable to P2 on the AMS-9050. 

The Metal Foil Detection enclosure can connect to 
relay-activated devices such as camera switchers 
or pager systems. You can then program the 
device to perform some function, such as switching 
cameras or sending a message to a pager. These 
devices are connected to P9 on the Metal 
Detection Board. 

Two relays are available on P9: Relay A (1) and 
Relay B (2). (Refer to Figure 2 for a pinout of P9.) 
Both of these relays are activated for one second 
when a metal event is detected. These relays are 
not configurable. If additional relays are needed, 
you can use the relays on the AMS-9050 controller; 
they are configurable on the Setup screen of the 
ADS4 Platform configurator. Refer to “Configuring 
the Alarm Settings” on page 29 for more 
information. 

 

 

AMC-7000 INTEGRATED METAL Foil DETECTION 

8200-2609-01, REV. 3a 

INSTALLATION GUIDE 

19 OF 31