Tyco Safety Products/Sensormatic AMS9050 Manuel D’Utilisation

Preliminary 

-  Verify that all equipment has arrived. Ensure the 

system configuration is correct for the site. 

-  Unpack major components in a back room. At 

the install site, lay out parts in the order used. 
Do not clutter the aisle or cause a trip hazard. 

-  Have electrical work comply with the latest 

national electrical code, national fire code, and 
all applicable local codes and ordinances. 

-  Coordinate work with other trades to avoid 

interference. 

-  Verify existing site conditions and coordinate 

with the owner’s representative and appropriate 
utilities as required. 

-  Obtain copies of all related plans, specifications, 

shop drawings and addenda to schedule and 
coordinate related work. 

-  Thoroughly review the project to ensure that all 

work meets or exceeds the above requirements. 
Bring alleged discrepancies to the attention of 
Sensormatic Electronics. 

-  The controller has a built-in flange used to 

attach the controller to a wall or ceiling using 
suitable hardware. Structure and hardware must 
support 25.6kg (56.4 lbs) or four times the 
weight of the controller assembly. 

-  Do not mount controller with its fan facing up. 

 During installation, if the 

antenna must be left unattended, turn off 
power or cover high voltage components 
to prevent unauthorized access to 
hazardous voltages. 

The ac power cord could be 

carrying 120Vac or 240Vac. 

 Do not install this device 

where highly combustible or explosive 
products are stored or used. 

The ac source must be a 2-

wire type with ground. It also must be a 
24-hour, unswitched outlet with less than 
0.5Vac between neutral and ground. 

This device is not suitable 

for an IT power distribution system 
where impedance exists between neutral 
and protective earth contacts. 

 When using a power cord, 

install a socket-outlet near the controller 
in an easily accessible location. The 
appliance coupler or plug on the power 
supply cord are the specified disconnect 
devices. 

 DO NOT share the ac source 

with neon signs, motors, computers, 
cash registers, terminals, or data 
communications equipment. 

 DO NOT use orange-colored 

outlets dedicated for computer 
equipment. 

 Select the appropriate power 

cord based on the country of use. 

AMC-7000 INTEGRATED METAL Foil DETECTION 

8200-2609-01, REV. 3a 

INSTALLATION GUIDE 

9 OF 31