Tyco Safety Products/Sensormatic UMEXCAL Manuel D’Utilisation
Preliminary
AMS-1070 CONTROLLER INSTALLATION GUIDE (8200-0127-06, REV. 0)
5 of 13
Connecting the Antennas
and Remote Alarm Module
and Remote Alarm Module
The cables from the antennas and remote alarm
module are inserted into the Aisle A and Aisle B
connectors. Table 1 below lists the signals the
cables carry.
module are inserted into the Aisle A and Aisle B
connectors. Table 1 below lists the signals the
cables carry.
Table 1. Controller Aisle connector pinout
Wire
Color
Color
Signal Description
Red Tx
-
Black Tx
+
Shield Shield*
Brown Piezo
Orange
Brown Piezo
Orange
RS-232 Rx (from pack)
Yellow
RS-232 Tx (from pack
Green Lamp
1
Blue Lamp
2
Violet +12V
Gray Digital
Gray Digital
Ground*
* Never connect shield to Digital Ground
The correct wiring method depends on the antenna
configuration. The following sections describe how
to wire each of the basic antenna configurations
listed in Table 2. A tall antenna is an alarming
antenna; a short antenna is a non-alarming
antenna.
configuration. The following sections describe how
to wire each of the basic antenna configurations
listed in Table 2. A tall antenna is an alarming
antenna; a short antenna is a non-alarming
antenna.
Table 2. Basic antenna configurations
Configuration
Alarming
Antenna
Antenna
Non-
Alarming
Antenna
Alarming
Antenna
Remote
Alarm
Module
Alarm
Module
Tall/short 1 1
0
Short/short 0 2 1
Regular split
Regular split
1
2
0
The EMI shields must be put on the antenna and
alarm cables before you connect the wires to the
connectors. Refer to the AMS-1070 EMI Shield
Installation Guide (8200-0127-12) before
proceeding.
alarm cables before you connect the wires to the
connectors. Refer to the AMS-1070 EMI Shield
Installation Guide (8200-0127-12) before
proceeding.
Connecting a tall and a short
antenna
If you are connecting an alarming antenna and a
non-alarming antenna to the controller, use Table 3
to connect the antennas.
non-alarming antenna to the controller, use Table 3
to connect the antennas.
Table 3. Antenna connector pinout
Cable Wire
Color Pin
Red 1
Non-alarming
Black 2
Non-alarming and Alarming Shield
3
Black 4
Red 5
Brown 6
Orange 7
Yellow 8
Green 9
Blue 10
Violet 11
Red 5
Brown 6
Orange 7
Yellow 8
Green 9
Blue 10
Violet 11
Alarming
Gray 12
Connecting two short antennas
and a remote alarm module
If you are connecting two non-alarming antennas
and a remote alarm module to the wiring harness,
use Table 4 to connect the antennas and remote
alarm module.
and a remote alarm module to the wiring harness,
use Table 4 to connect the antennas and remote
alarm module.
Table 4. Antenna connector pinout
Cable Wire
Color Pin
Red 1
Non-alarming 1
Black 2
Non-alarming 1 and 2 and
remote alarm module
remote alarm module
Shield 3
Black 4
Non-alarming 2
Red 5
Brown 6
Orange 7
Yellow 8
Green 9
Blue 10
Violet 11
Brown 6
Orange 7
Yellow 8
Green 9
Blue 10
Violet 11
Remote alarm module
Gray 12