Emerson Liebert MC Microchannel Outdoor Condenser 28 - 220kW Manuel D’Utilisation
Site Preparation
9
Liebert
®
MC
™
Figure 5
Condenser planning dimensions–MCM120
Leg Height
A *, In. (mm)
B
In. (mm)
C
In. (mm)
18 (457)
31-5/8 (803)
39-5/8 (1006
36 (914)
49-5/8 (1260)
57-5/8 (1464)
48 (1219)
61-5/8 (1565)
69-5/8 (1768)
60 (1524)
73-5/8 (1870)
81-5/8 (2073)
* 18" legs standard for all models. Cross-bracing required for legs longer than 18". Number varies according to model and options.
See Tables 1 and 2 for weights, including added weight for legs of various lengths.
Source: DPN002555, Rev. 1
See Tables 1 and 2 for weights, including added weight for legs of various lengths.
Source: DPN002555, Rev. 1
A
Shown with typical 60" legs.
152-3/4"
(3880mm)
46-1/4"
1175mm
B
C
A
144-5/16"
(3666mm)
Liebert DSE receiver adds
8-1/2" (216mm) to the unit
width and may be mounted
on the right or left side.
8-1/2" (216mm) to the unit
width and may be mounted
on the right or left side.
DETAIL A
Electrical Box End
46"
(1169mm)
Fastener assembly,
fender washer and
hex nuts.
4 each required,
2 places
fender washer and
hex nuts.
4 each required,
2 places
Spacer
2 each required,
2 places
2 each required,
2 places
Emerson recommends a clearance of
36" (915mm) on each end and each side
for proper operation and component access.
36" (915mm) on each end and each side
for proper operation and component access.
46-5/16" (1177mm)
39-5/16"
(999mm)
(999mm)
44-3/8"
(1127mm)
(1127mm)
1-7/8"
(48mm)
(48mm)
94-7/16"
(2398mm)
Install two (2) each 1/8"(3.18mm)
leg spacers in each of these
locations (see note below)
leg spacers in each of these
locations (see note below)
NOTE:
Install (2) two condenser leg spacers, part number 304679P1, in two places where shown, between each pair of legs
that adjoin each other.
Use (4) four of part number: 301375G1 (fastener assembly), 301369P1 (washer fender) and 301392P1 (nut hex),
to secure each pair of legs and spacers together.
Install (2) two condenser leg spacers, part number 304679P1, in two places where shown, between each pair of legs
that adjoin each other.
Use (4) four of part number: 301375G1 (fastener assembly), 301369P1 (washer fender) and 301392P1 (nut hex),
to secure each pair of legs and spacers together.
DPN002555
Rev. 1
Rev. 1
ANCHOR PLAN
For typical footprint
dimensions, see Figure 2
See table below for
dimensions A, B and C