Manuels d'utilisation pour ATTO Technology 3400

Table des matières

• 1 Fibre Channel is a key technology for storage

  6
  • Glossary

    6
• 2 ATTO FibreCenter supports diverse SAN needs

  8
  • Quick start instructions

    8
  • Exhibit 2-1 Single zone configuration (Zone 1), an eight-port hub configuration. Ports 2, 3, 4, ...

    8
  • Exhibit 2-2 Dual-zone configuration (Zone 2 and Zone 3). Each zone is independent of the other, ...

    9
• 3 ATTO FibreCenter 3400 characteristics

  10
  • Specifications

    10
  • Local and network management

    10
  • Features

    10
  • Exhibit 3-1 Front view of the FibreCenter 3400

    11
  • Exhibit 3-2 Module view of the FibreCenter 3400

    11
• 4 Setting up the FC Rack System

  12
  • Physical dimensions

    12
  • Operating environment

    12
  • Mounting

    12
  • Air flow and cooling

    12
  • Internal power distribution

    12
  • Exhibit 4-1 Rack System power module

    13
  • Exhibit 4-2 Cooling airflow patterns

    13
• 5 Setting up the ATTO FibreCenter

  14
  • Connecting Fibre Channel ports

    15
  • Cabling

    15
• 6 Configuring the ATTO FibreCenter

  16
  • Data transfer when setting up zones

    16
  • FibreCenter behavior on reset or power-up

    16
  • Zone 1

    16
  • Zone 2 and Zone 3

    16
  • Exhibit 6-1 Single zone configuration (Zone 1), an eight-port hub configuration. Ports 2, 3, 4, ...

    17
  • Exhibit 6-2 Dual-zone configuration (Zone 2 and Zone 3) as designated by the Setup and Switch co...

    17
• 7 Command Line Interface use and guidance

  18
  • CLI command conventions

    18
  • Exhibit 7-3 Command conventions. Do not type symbols when entering commands.

    19
  • Exhibit 7-4 A typical command/response sequence during a Telnet session.

    19
• 7.1 Ethernet and Telnet configuration commands

  20
  • Default Router

    20
  • Echo

    20
  • Factory Defaults

    20
  • Idle Timeout

    20
  • IP Address

    20
  • Security Traps

    20
  • Subnet Mask

    20
  • Telnet

    20
  • Telnet Status

    20
• 7.2 Diagnostic commands

  21
  • Status

    21
  • Telnet Status

    21
  • Version

    21
• 7.3 Configuration commands

  22
  • Flush

    22
  • Rate

    22
  • Reset

    22
  • Setup

    22
  • Switch

    22
  • Switch Delay

    22
  • Exhibit 7.3-1 Command line interface setup commands and get switch returns for Zones 1, 2 and 3

    23
• 8 Updating firmware

  24
• 9 Troubleshooting

  25
• Index: Command Line Interface

  26
• Appendix A Standards and compliances

  27
  • UL 1950 3rd Edition

    27
  • FCC Standards: Radio and Television Interference

    27
  • Canadian Standards

    27
  • European Standards: Declaration of Conformity

    27
• Appendix B Contact ATTO Technology, Inc.

  28