Desa KEROSENE HIGH PRESSURE PORTABLE FORCED AIR HEATERS Manuale Utente
www.desatech.com
110098-01F
6
OFF
ENGINE
FUEL
F
Figure 5 - Typical Generator Grounding
Method (Generator construction may
vary from that shown)
Ground
Lug
Lug
Ground Wire
(#10 AWG -
Stranded-Copper)
(#10 AWG -
Stranded-Copper)
Alternator
Copper
or Brass
Grounding
Point
or Brass
Grounding
Point
PREVENTATIVE MAINTENANCE SCHEDULE
WARNING: Never service heater while it is plugged in, operating
or hot. Severe burns and electrical shock can occur.
Item
Fuel tank
Filler neck screen
Fuel filter assembly (Fuel
tank)
Fuel filter lines
Fuel filter (In pump or ex-
ternal canister)
Spark plug
Fan blades and air
deflectors
Air passages around burner
head
Motor
How To
See Storing,
, page 5
Lift out of fuel tank and rinse with
clean kerosene
See Fuel Filters, page 12
See Fuel Lines, Page 12
See Fuel Filters, page 12
See Spark Plug, page 10
See Fan Blades and Air Deflec-
tors, page 10
Remove debris and trash with a
clean, soft cloth
How Often
Flush every 150-200 hours of operation
or as needed
Check for particles in fuel when filling
fuel tank. Clean when dirty
Clean twice a heating season or replace
as needed
Check and tighten loose connections
occasionally
Clean fuel filter element every 250
hours
Clean and regap every 300 hours of
operation or replace as needed
Clean each season or as needed
Check each season for dirt and
debris
Not required, permanently lubricated
OPERATION WITH
PORTABLE GENERATOR
WARNING: Before operating
heater or any appliance from a
portable generator, verify that
generator has been properly con-
nected to earth ground. Improper
grounding or failure to ground
generator can result in electro-
cution if a ground fault occurs.
Refer to owner’s manual supplied
by generator manufacturer for
proper grounding procedures.
The operating voltage range of the heater is 108 to
132 Volts (120 Volts +/- 10%). Prior to plugging
heater into generator the output voltage should
be verified (if generator is equipped with the au-
tomatic idle feature, the output voltage should be
measured with the generator running at full speed).
If the voltage does not measure in this range the
heater should not be plugged into the generator.
Refer to Operation, page 4, for starting, stopping
Refer to Operation, page 4, for starting, stopping
and resetting heater procedures.