Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
12
Configuring GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE Cards Using PCLI
OL-25022-01
DLP- G522 Apply a Service Instance Policy to a Port on GE_XPE or 10GE_XPE Cards Using PCLI
NTP-G216 Enable Link Integrity on GE_XP, 10GE_XP, GE_XPE, or
10GE_XPE Cards Using PCLI
10GE_XPE Cards Using PCLI
Note
Step 1
Complete the
at the node where you want
to enable link integrity. If you are already logged in, continue with
Step 2
Complete the following tasks, as needed:
Step 4
mac-address-table learning interface
<type> <port>
Example:
MSTP-176(config)# mac-address-table
learning gigabitethernet 2
Enables interface based learning of MAC address. Repeat the
command on each SVLAN to enable MAC address learning.
command on each SVLAN to enable MAC address learning.
Step 5
exit
Example:
MSTP-176(config)# exit
Exits global configuration mode.
Step 6
Return to your originating procedure (NTP). —
Purpose
This procedure explains how to enable link integrity on GE_XP, 10GE_XP,
GE_XPE, or 10GE_XPE cards using PCLI.
GE_XPE, or 10GE_XPE cards using PCLI.
Tools/Equipment
None
Prerequisite Procedures
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Command or Action
Purpose
Step 1
configure terminal
Example:
MSTP 176# configure terminal
Enters global configuration mode.
Step 2
vlan profile name
Example:
MSTP 176 (config)# vlan profile
profile4
MSTP 176 (config-profile)
Enters VLAN profile configuration mode.
Command or Action
Purpose