Cisco Cisco Content Delivery Engine 250 Guida All'Installazione

CPU1 VTT Voltage 1.34 0.92 1.13
CPU2 VTT Voltage 1.65 0.92 1.13
CPU1 DIMM Voltage 1.65 1.20 1.36
CPU2 DIMM Voltage 1.65 1.20 1.37
+1.5V Voltage 1.65 1.35 1.45
+1.8V Voltage 1.98 1.62 1.78
+5V Voltage 5.50 4.51 5.02
+12V Voltage 13.19 10.80 12.13
+1.1V Voltage 1.21 0.98 1.10
+3.3V Voltage 3.65 2.95 3.29
+3.3Vsb Voltage 3.65 2.95 3.24
VBAT Voltage 3.65 2.95 3.00
CPU1 Temperature 95/203 Low
CPU2 Temperature 95/203 Low
System Temperature 75/167 37/98
Power1 Temperature 80/176 37/98
Power2 Temperature 80/176 38/100
Chassis Intrusion Good
Power Supply Failure Good
Power1 Supply Failure Good
Power2 Supply Failure Good
--------------------------------------------- Fri Mar 20 13:08:12 2015

Note: if sdt returns the following error:

*****************************************************************************
SuperDoctor II - Linux version 2.88(120726)
Copyright(c) 1993-2012 by Super Micro Computer, Inc.

http://supermicro.com/

*****************************************************************************
Error: no i2c device files found. Please use mkdev.sh to create them.

Run the following command: /usr/sbin/enable_ipmi.sh
Then run the “sdt” CLI command again.

2.3.3 Validation on VDS-IS (Release 3.2)

For Release 3.2 (and beyond), simply execute the “show hardware health” CLI
command. Verify this command does not hang, and that the IPMI firmware version indicates
“3.6” (example output is shown below):

DD13-2S10-2#sh hardware health

----------------- System Hardware Health ------------------

*****************************************************************************
  Supero Doctor II - Linux version 2.79(110504)
  Copyright(c) 1993-2010 by Super Micro Computer, Inc. http://supermicro.com/
*****************************************************************************
Monitored Item High Limit Low Limit Status
----------------------------------------------------------------------
Fan1 Fan Speed 715 5625