HP designjet l65500 Manuale Di Servizio

 Troubleshooting

221

If not, perform again the Printhead cleaning roller. The details of the static wipe are described below: 

Restart the printer in diagnostic boot mode and perform the following tests: 

•

7.1 Printhead Roll Adv Open Loop, include the test of the Electromechanical break. 

•

7.2 Printhead Roll Adv Close Loop, to test the advance of the Printhead cleaning material 

•

7.4 Printhead Roll Eng Close Loop, to test the engage movement (up/down movement of the 

Printhead cleaning roller). 

In this case of intermittent movement failure of the Printhead cleaning roller, a greasing of the Printhead 

cleaning roller is recommended. 

Here are the different items to grease (removal of the Printhead cleaning roller is required, printer has to 

be switched off first.  

The  grease  to  use  should  be  compatible  with  plastic  and  metal,  as  in  Molicote  44.  In  case  of 

 any  doubt,  order  the  support  part  ‘Q6702-67013 Grease kit for the PH cleaning roller’.  

If the printhead is experiencing a one time fault, use the following procedure to troubleshoot the error 

before replacing it.