HP designjet l65500 Manuale Di Servizio
Tr
ou
bles
hooting
224
Troubleshooting
To perform the cleaning use the Cleaning kit
(CK832A) included with the printer, see photo.
Use the following procedure to clean fiber/dirt
from electrical contacts.
1.
Remove the Printhead as described in the
User’s Guide to gain access to the Car-
riage Printhead Interconnect board.
2.
Once the printhead has been removed
look down into the empty printhead.s slot.
Check the status of the electrical contacts
which are located there. If necessary use
a light to check the contacts.
3.
TIP: To clearly see the electrical contacts,
place a small piece of Z-folded paper
down into the slot to highlight the contacts
4.
If the contacts on the printer interconnect
board are dirty and have fibers on them,
this will cause the reseat/replace error
messages.
5.
Turn off the printer with the ACB1 switch
and use the brush from the cleaning kit to
carefully clean the contacts of dirt/fibers.
Use care when cleaning so that none of
the contacts are damaged.
6.
After thoroughly cleaning the printhead
interconnect contacts with the brush, use
the Pneumatic air gun to blow any resid-
ual dirt from the contacts and the general
area.