HP designjet l65500 Manuale Di Servizio

 Troubleshooting

231

a.

Decrease the vacuum level (mainly for substrate width of 3.2m or 2 m, covering all the printz-

one.

b.

Check that the vacuum level is not constantly at 100% (export the service plot when the printer 

is in ready, documented within the chapter 3, within the section ‘page 251’).

c.

Increase tensions on the output.

5.

LX800 only: In the Roll to Free floor, in case of wrinkles as shown below, between the diverter and 

the tension roller, reduce the force applied by the pinchwheels, refer to the Maintenance and Trou-

bleshooting guide on page 48.