HP designjet l65500 Manuale

Turn off the printer.

Place a piece of paper underneath the carriage to collect any dirt that falls through.

Use the brush from the Cleaning Kit to clean the electrical connections gently but thoroughly.

Use the pneumatic air gun (provided for inflating the spindles) to dislodge any remaining dirt.
You can use paper or cloth to prevent the spread of dirt.

Remove any paper or cloth you have used to prevent the spread of dirt.

Again illuminate the electrical connections and check that they are clean and undamaged.

Reinsert the printhead into the carriage and check the front panel message.

If the problem persists, insert a new printhead.

If the problem still persists, call your service representative (see 

).

A printhead may overheat for several reasons.

●

The room temperature may be too high.

●

The printhead may be suffering from blocked nozzles. You may be able to cure this problem by
cleaning the printheads (see 

●

The printhead may be suffering from an internal failure, in which case it must be replaced.

When a printhead touches and damages the substrate, the most likely cause is excessive heat.
Therefore, try decreasing the drying temperature.

For information on how to adjust printer settings, see the User's guide.

You should not touch the printhead cleaner roll except when you need to replace it. Any interference
with the roll may prevent the printer from keeping track of roll usage, in which case you may see spurious
error messages, and a printing job may be cancelled unnecessarily.

ENWW

A printhead has overheated

41