HP digital sender 9200c Manuale Di Servizio
MAC address is stored as part of the formatter and not stored in the compact flash card. Some
network reconfiguration might be necessary.
network reconfiguration might be necessary.
Verifying communication over the network
If the HP Jetdirect configuration page shows an IP address for the digital sender, use this procedure
to verify that the digital sender is communicating with other devices on the network.
to verify that the digital sender is communicating with other devices on the network.
To verify communication over the network
1
On a computer open a command prompt. Click Start, click Run, and then type
cmd
. An MS-DOS
command prompt opens.
2
Type
ping
followed by the IP address. For example, type
ping XXX.XXX.XXX.XXX
where
"XXX.XXX.XXX.XXX" is the IP address that appears on the HP Jetdirect configuration page. If
the digital sender is communicating over the network, the response is a list of replies from the
digital sender.
the digital sender is communicating over the network, the response is a list of replies from the
digital sender.
3
Verify that the IP address is not a duplicate address on the network by using the address
resolution protocol (arp -a) command. At the prompt, type
resolution protocol (arp -a) command. At the prompt, type
arp -a
. Find the IP address in the list
and compare its physical address to the hardware address that is listed on the HP Jetdirect
configuration screen in the section called HP Jetdirect Configuration. If the addresses match, all
network communications are valid.
configuration screen in the section called HP Jetdirect Configuration. If the addresses match, all
network communications are valid.
4
If you cannot verify that the digital sender is communicating over the network, contact the
network administrator.
network administrator.
174
7 Troubleshooting