Honeywell International Inc. WFSADPT Manuale Utente
PRELIMINARY: Notifier Wireless Sensor Network — P/N LS10036-000NF-E:N0 10/10/2013
43
Configuration and Programming
Devices
3.6.3 Mesh Formation
To add a device to a mesh, refer to the topic, "Mesh Formation with PC Tools" or, to form a mesh
network, ensure that the FWSG is powered on and contains a profile. Activate the mesh formation
magnet sensor (Figure 2.8, “Mesh Formation Magnetic Sensor on a FWSG”) on the FWSG.
Repeater
The Notifier’s Wireless Sensor Network does not require the use of a dedicated repeater; all wire-
less devices act as repeaters. When the repeater function is needed in a location where there is no
specific fire function is required, a wireless monitor module or another device can be installed to
fulfill the function as a repeater.
3.6.4 Restoring a Device to Factory Default
Removing Profiles without PC-based Configuration Tool
A device can be restored to factory default state by following the below steps.
1. Start with the device powered off. The process is performed during the start-up.
2. Power on the device by inserting a single battery into any slot in the device. The LEDs
2. Power on the device by inserting a single battery into any slot in the device. The LEDs
blink yellow twice every five seconds for one minute continuously after inserting the
battery.
3. Toggle the code wheel address pattern to 0-159-0. To toggle the SLC code wheel address,
• Set the address to 0
• Change the address to 159
• Change the address back to 0.
• Set the address to 0
• Change the address to 159
• Change the address back to 0.
NOTE: The above illustration depicts the rotary switches being set at address 35 (rotary switch
on 'TENS' set at 3 and rotary switch on 'ONES’ set at 5. Ensure that the code wheel address
pattern is toggled within 1 minute of inserting the battery.
on 'TENS' set at 3 and rotary switch on 'ONES’ set at 5. Ensure that the code wheel address
pattern is toggled within 1 minute of inserting the battery.
After the code wheel pattern is set, the LEDs in the device blink green five times followed by a sin-
gle or double red blink confirming that the device has reverted back to factory default condition.
Removing Profile with PC Tools
To remove a profile in a device using the PC Tools application, do the following:
1. Connect the W-USB dongle device to your computer. For more information on USB dongle,
1. Connect the W-USB dongle device to your computer. For more information on USB dongle,
2. Launch the PC Tools application. Refer Appendix B:, "PC Tools" to know about launching the
PC Tools application.
3. Go to Site Survey, Create Mesh Network or Diagnostics step.