Honeywell International Inc. CS19A Manuale Utente

3 - 24

To see what the factory default settings are, refer to the table of 

 beginning on page 11-5.  The standard product default settings for 

each of the commands are indicated by an asterisk (*).  
Note: Scanning this bar code also causes both the scanner and the base to 

perform a reset and become unlinked.  The scanner must be placed in its 

for additional information.

If your scanner is in multiple scanner mode, you will hear up to 30 

seconds of beeping while all scanners are re-linked to the base and the 

settings are changed. 

If you want the custom default settings restored to all of the work groups, scan 
the Custom Product Default Settings bar code below.  (If there are no custom 

defaults, it will reset the work groups to the factory defaults.)  See 

 on page 1-9 for further information about custom defaults.

Note: Scanning this bar code also causes both the scanner and the base to 

perform a reset and become unlinked.  The scanner must be placed in its 

for additional information.  

If your scanner is in multiple scanner mode, you will hear up to 30 

seconds of beeping while all scanners are re-linked to the base and the 

settings are changed. 

The scanner can be used either with the CCB01-010BT charge base or with 
other Bluetooth devices.  Those devices include personal computers, laptops, 
PDAs, and Honeywell mobility systems devices.

Scanning the Non-Base BT Connection bar code below allows the scan-
ner to be used with other Bluetooth devices (e.g., PC/laptop).  After you 
scan the bar code below, follow the instructions supplied with your Blue-

tooth device to locate the scanner and connect to it.  If you go out of range 

Preliminary Draft