Honeywell International Inc. MX2702 Manuale Utente

If your scanner is out range of the base, an alarm sounds from both your base 
and scanner if they are programmed to emit an alarm.  To activate the alarm 
options for the scanner or the base and to set the alarm duration, scan the 
appropriate bar code below and then set the time-out duration (from 0-3000 
seconds) by scanning digits on the 

 inside the back cover, 

then scanning Save.  

Default = 0 sec (no alarm).

Note: If you are out of range when you scan a bar code, you will receive an error 

beep even if you do not have the alarm set.  You receive the error beep 
since the data could not be communicated to the base or the host.

If you have set the out-of-range alarm enabled, you may change the alarm type 
for the scanner or base by scanning the appropriate bar code below and then 
scanning a digit (0-7) bar code and the Save bar code on the 

 

inside the back cover of this manual.  

Default = 0.  Set the sound type to fit your 

application.

Base Duration Alarm

Scanner Duration Alarm

Base Alarm Type

Scanner Alarm Type