Applied Concepts Inc ACMI006 Manuale Utente

 
 
 

 

 

Perform the tuning fork test on the radar before using for traffic 
measurements.  See page 20 for instructions on this procedure. 

Select stationary mode by pressing the MOV/STA key on the remote 
control, then select the desired antenna by pressing the ANT key.  To 
transmit, press the XMIT/HOLD  key.    The  XMIT icon should 
appear on the display unit (Fig 3) indicating that a radar signal is 
being transmitted. 

Fi 3 

g 

If a target is in range, such as one traveling 54 mph, the speed will 
appear in the target window of the display unit (Fig 4); and a Doppler 
audio tone, which is proportional to the target speed, will be heard 
from the speaker.  The target speed is continually measured and 
displayed, and the Doppler audio tone is heard as long as the target is 
present. 

Fi 4 

Hold mode can be selected by pressing the XMIT/HOLD key on the 

g 

remote control.  In hold mode, The XMIT icon will be off 
(Fig 5) and no signal will be transmitted, preventing detection by 
radar detectors. 

NOTE: While o
OPTION” on Page 21) the radar uses the presence (or absence)
VSS pulses to automatically switch between moving mode and 
stationary mode. 

 

Fig 5 

 

 

ote 

Perform the tuning 
measurements.  See page 20 for instructions on this procedure. 

Select moving mode by pressing the MOV/STA key on the rem
control. When S 

is in moving mode, the patrol 

window will contain either the patrol speed or a [ ].  The [ ] (Fig 6) 
indicates that S 

is in moving mode, but has no 

ground speed.  Select opposite lane mode by pressing the 
SAME/OPP key until the SAME icon is not visible.  To transmit, 
press the XMIT/HOLD key.  The XMIT icon should appear on the 
display unit (Fig 6) indicating that a radar signal is being transmitted. 
Be sure the patrol speed indicated corresponds to the speedometer of 
the patrol vehicle.  If an approaching target is in the radar beam, its 
speed will appear in the target window and a Doppler audio tone will 
be heard from the speaker.  Fig 7 is an example in which the patrol 
speed is 50 and the approaching target speed is 68.  The target speed 
is continually measured and displayed and the Doppler audio tone is 
heard while the S 

is in transmit mode and a target is 

present. 

Fig 6 

Fig 7 

 

8