Honeywell International Inc. WFSSM Manuale Utente

14

SWIFT® Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000SK-E:B  11/9/2017

WSK-WGI Wireless System Gateway

To power the gateway using the signaling line circuit, connect the gateway as described in the table and graphic below:

    

The gateway provides isolation of short circuits on the SLC in Class A (Style 6) installations. SLC connections are power-limited by the 

panel. An interruption in the SLC that causes a loss of power at the gateway for more than 100ms may result in a trouble condition and 
loss of fire protection provided by the wireless devices for approximately 15 minutes. Use of an external +24V power source (not SLC 
power) is recommended for installations that require fire protection in the presence of short circuits, including Class A applications and 

applications that use isolator modules.

To power the gateway using an external, regulated +24VDC source, connect the gateway as described in the table and drawing below.

A5 and A7 SLC - (Common) & SLC Output +

A5 and A6 SLC - (Common) & SLC Input +

A4 and A5 Jumper selection to enable power from the SLC supply. (Insert Jumper when using SLC power.)

A3

Unused

A1 and A2 Jumper selection to enable power from the SLC supply. (Insert Jumper when using SLC power.) 

+

+

-

-

SLC out to next device (Class B)
or SLC return to FACP (Class A)

SLC in from FACP/device

jumpers

2.

5.w

m

f

NOTE: Use of the same wire gauge is recommended if there are multiple connections to the same terminal.

A5 & A7

SLC Output

A5 & A6

SLC Input

A4

Unused

A2 & A3

+24VDC input. Voltage range from +18VDC to +30VDC.
Use only power-limited device circuits.

A1

Unused