Honeywell International Inc. WFSSM Manuale Utente

12

SWIFT® Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000SK-E:B  11/9/2017

WSK-WGI Wireless System Gateway

The gateway has two major pieces, the cover and the mounting plate. The mounting plate is mounted to the wall or ceiling, and field wir-
ing is connected to it. The cover contains the printed circuit board and is fastened to the mounting plate once the wiring is completed. 
Mount the mounting plate directly to an electrical box on the ceiling or wall. The plate mounts directly to a 4˝ square (with and without 
plaster ring), 4˝ octagon, 3 1/2˝octagon, single gang or double gang junction boxes. If an electrical box is not available, the mounting 
plate can be mounted to any flat surface and the wiring can be connected via the knockout points in the mounting plate. 
To mount the gateway:
1.

Pull the wiring through the opening in the mounting plate.

2.

Mount the mounting plate to the junction box or ceiling. See Figure 2.3 below.

3.

Connect field wiring to the terminals, as described in Section 2.7.2.

4.

Connect necessary jumpers where applicable, as described in Section 2.7.3.

5.

To mount the cover, align the locating pins on the cover to the corresponding slots in the mounting plate. See Figure 2.4.

6.

Secure the cover by tightening the mounting screws.

 

WARNING: FORMEX SHEET
ENSURE THAT THE FORMEX SHEET INSIDE THE GATEWAY IS NOT REMOVED OR TAMPERED WHILE INSTALLING 

OR CLEANING.

2.

2

.w

m

f

locating pin

locating pin

locating pin