ICOM 325000 Manuale Utente
29
6
SCAN OPERATION
qPush [V/M] to select the VFO mode.
• Push [BAND] to select a desired frequency band.
wSet the squelch level.
e Hold down [SCAN](MODE) for 1 second to enter the scan
type selection mode.
rRotate [DIAL] to select a desired scanning type.
• Select “ALL” for full scan, “BAND” for band scan, “P-LINK x” for
programmed link scan (x= 0 to 9), “PROGxx” for programmed
scan (xx= 0 to 24; only programmed scan edge numbers are
displayed).
scan (xx= 0 to 24; only programmed scan edge numbers are
displayed).
[DIAL]
Selectable between
“0” to “24” if programmed
Selectable between
“0” to “9” if programmed
• Full scan
• Band scan
• Program link scan
• Program scan
Rotate
Hold down
for 1 sec.
for 1 sec.
tTo start the scan, push [SCAN](MODE).
• The scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also
• Rotate [DIAL] to change the scanning direction. This also
resumes scanning.
• Push [SCAN](MODE) again to stop the scan.
During full/band scan
During programmed/
link program scan
link program scan
NOTE: Instead of doing steps
e to t, while holding
down [SCAN](MODE), rotate [DIAL] to select a desired
scan type. In this case, the scan starts after releasing
[SCAN](MODE).
scan type. In this case, the scan starts after releasing
[SCAN](MODE).
About the scanning steps: The VFO mode, the selected
tuning step in each frequency band is used during the
scan.
tuning step in each frequency band is used during the
scan.
N Full/band/programmed link/programmed scan