ICOM 325000 Manuale Utente
30
6
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
N Scan edges programming
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edge memory channels, 00A/00B to 24A/24B.
memory channels. Scan edges are programmed into scan
edge memory channels, 00A/00B to 24A/24B.
qPush [V/M] to select the VFO mode.
wSet a desired frequency:
± Push [BAND] to select a desired band.
± Rotate [DIAL] to set a desired frequency.
± Set other data
± Rotate [DIAL] to set a desired frequency.
± Set other data
(e.g. offset frequency, duplex direction, tone
squelch, etc.)
, if desired.
e Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The “
• The “
” icon and memory channel number blink.
r Rotate [DIAL] to select a desired programmed scan edge
channel from 00A to 24A.
tHold down [S.MW](V/M) for 1 second.
• 3 beeps sound
• The matched “B” channel is automatically selected when hold-
• The matched “B” channel is automatically selected when hold-
ing down [S.MW](V/M) after programming.
y To program a frequency for the other pair of scan edges,
00B or 24B, repeat steps
w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
Rotate
Hold down
for 1 sec.
to select channel 03A.
Hold down
for 1 sec. to program.
The VFO mode
Enter the select memory write mode.
Return to the VFO mode.
[EXAMPLE]: Programming 145.370 MHz into scan edge channel 03A (a blank channel).