Insys GPRS 5.0 serial 11-02-01-03-10.014 Manuale Utente
Codici prodotto
11-02-01-03-10.014
INSYS GPRS 5.0 serial
FAQ
Mai 06
73
Problem:
Possible cause:
Remedy
Manual dialing of
ATD<ip>:<port> or
ATD<domain>:<port> is
not possible. After a
few seconds, the mes-
sages No Carrier or
No Dialtone are
displayed.
ATD<ip>:<port> or
ATD<domain>:<port> is
not possible. After a
few seconds, the mes-
sages No Carrier or
No Dialtone are
displayed.
The GPRS dial-in parame-
ters have not been set cor-
rectly.
ters have not been set cor-
rectly.
Step 1:
Read out all data using the button
from the device and
check the settings.
check the settings.
Step 2:
On the tab "TCP transparent" check the
selection of the network provider.
selection of the network provider.
For some network providers, PAP au-
thentication is required.
thentication is required.
Please find a selection of network pro-
viders for German speaking countries
(Germany, Austria, and Switzerland) in
Chapter 11 “GPS Dial-in Parameters” or
ask the customer center of your provider
for the correct settings.
viders for German speaking countries
(Germany, Austria, and Switzerland) in
Chapter 11 “GPS Dial-in Parameters” or
ask the customer center of your provider
for the correct settings.
Step 3:
Change the settings, if needed, and re-
start the INSYS GPRS 5.0 serial.
start the INSYS GPRS 5.0 serial.
Step 4:
Switch to the terminal program
and manually dial into the GPRS net-
work. Enter the AT command
ATD*99***1#. The successful connec-
tion setup is confirmed with the mes-
sage Connect.
work. Enter the AT command
ATD*99***1#. The successful connec-
tion setup is confirmed with the mes-
sage Connect.