LXE Home Security System E-EB-VX6UG-E Manuale Utente

 

 

1.  Place lock washer first, then flat washer on 1/4-20x5/8 bolt.  Next insert mounting bolts 

through the curved apertures in the bottom mounting bracket and into the screw holes on 
the side of the back mounting bracket. 

2.  Loosely tighten each bolt as it is inserted.  

adjusted. 

3.  Loosen the hex bolts on both sides to adjust the viewing angle of the mounted VX6. 
4.  Torque the hex bolts to 50±5 in lbf (5.64±.56 N m). 
 

Note:  Test the torque on the bolts frequently during operation and re-tighten if 

necessary to 50±5 in lbf (5.64±.56 N m). 

6.  If using a UPS battery pack, the battery pack can be mounted to the bottom mounting 

bracket.  Place a locking washer and then a flat washer on a 1/4-20x2 bolt.  Thread the bolt 
through the UPS Battery Pack, then through the 1” aluminum spacer and into the mounting 
bracket. 

7.  Connect all cables to the VX6. Secure the cables with the strain relief cable clamps, ensuring 

a slack loop remains between the cable clamp and the accessory connector. 

8.  The vehicle mounted bracket and the VX6 are now ready to use. 

The LXE stylus kit includes the stylus, tether and sleeves.  The tether allows the stylus to be 

mounted to the VX6 and the sleeve provides storage for the stylus when not in use. 

Locate the tether holes on the top of the VX6.  (see below): 
Select the mounting hole most convenient for the particular VX6 installation. 
Slide the clip end of the stylus tether into the tether mounting hole. 
Determine a convenient location for the stylus sleeve.  Apply the adhesive baked Velcro

®

 loop 

strip to the VX6.  Attach the Velcro

®

 hook strip on the elastic stylus sleeve to the loop strip.