Friedrich 920-087-09 ユーザーズマニュアル

13

TEST  BEFORE EACH USE 

1. PRESS RESET  BUTT ON 

2. PLUG LCDI INT O POWER   

    RECEPT ACLE 

3. PRESS  TEST  BUTT ON, 

    RESET  BUTT ON SHOULD       

                 POP  UP 
4. PRESS  TEST  BUTT ON,   

    FOR USE 

DO NOT  USE IF  ABOVE  TEST 

F AILS 

WHEN GREEN LIGHT  IS ON 

IT  IS WORKING PROPERL Y 

TEST  BEFORE EACH USE 

1. PRESS RESET  BUTT ON 

2. PLUG LCDI INT O POWER   

    RECEPT ACLE 

3. PRESS  TEST  BUTT ON, 

    RESET  BUTT ON SHOULD       

    POP UP 
4. PRESS  TEST  BUTT ON,   

    FOR USE 

DO NOT  USE IF  ABOVE  TEST 

F AILS 

WHEN GREEN LIGHT  IS ON 

IT  IS WORKING PROPERL Y 

FRP014

  HACR – Heating, Air Conditioning, Refrigeration

*  May be used for 15 Amp applications if fused for 15 Amp

  NOTE:   265 volt units are hard wired.

Use ONLY type and size fuse or HACR cir-

cuit breaker indicated on unit’s rating plate.  

Proper current protection to the unit is the 

responsibility of the owner.  NOTE: A time 

delay fuse is provided with 265V units.

Unit MUST be grounded from branch circuit 

through service cord to unit, or through 

separate ground wire provided on per-

manently connected units.  Be sure that 

branch circuit or general purpose outlet is 

grounded.  The field supplied outlet must 

match plug on service cord and be within 

reach of service cord.  Refer to Table 1 for 

proper receptacle and fuse type.  Do NOT 

alter the service cord or plug.  Do NOT use 

an extension cord.

The field supplied outlet must match plug on 

service cord and be within reach of service 

cord.  Refer to Table 1 for proper receptacle 

and fuse type.  Do NOT alter the service 

cord or plug.  Do NOT use an extension 

cord.

All Friedrich 230/208V PTAC units are shipped from the factory with a 

Leakage Current Detection Interrupter (LCDI) equipped power cord.  The 

LCDI device meets the UL and NEC requirements for cord connected air 

conditioners effective August 2004.
To test your power supply cord:

1.  Plug power supply cord into a grounded 3 prong outlet.
2.  Press RESET.
3.  Press TEST ( listen for click; Reset button trips and pops out).
4.  Press and release RESET (listen for click; Reset button latches 

and remains in).  The power supply cord is ready for operation.

NOTE: 

The LCDI device is not intended to be used as a switch.

Once plugged in the unit will operate normally without the need to reset 

the LCDI device.
If the LCDI device fails to trip when tested or if the power supply cord is 

damaged it must be replaced with a new supply cord obtained from the 

product manufacturer, and must not be repaired.

NOTE: 

Use Copper Conductors ONLY.  Wire sizes are per NEC, check local codes for overseas applications.

Turn off electrical power before service

or installation.

ALL electrical connections and wiring

MUST be installed by a qualified

electrician and conform to the National

Code and all local codes which have

jurisdiction.

Failure to do so can result in property

damage, personal injury and/or death.