Heatiator ECO-ADV-WS22 ユーザーズマニュアル

40

Heatilator • ECO-ADV-WS22 • 7057-128C • August 13, 2010

10.  Burn  wood  only.    Other  types  of  fuels  may  generate

poisonous gases (e.g., carbon monoxide).

11.  If  unit  burns  poorly  while  an  exhaust  blower  is  on  in

home, (i.e., range hood), increase combustion air.

12.  Installation shall be in accordance with the Manufacturers

Home & Safety Standard (HUD) CFR 3280, Part 24.

1.  An outside air inlet must be provided for combustion See

page 39 for installation information.

2.  Appliance must be secured to the mobile home structure

at two attachment points by bolting the pedestal through

hearth pad and into floor.

3.  Appliance  must  be  grounded  with  #8  solid  copper

grounding wire or equivalent and terminated at each end

with N.E.C. approved grounding device.

4.  Appliance must be installed with an approved UL103 HT

ventilated chimney connector, UL103 HT chimney, and

terminal cap with spark arrestor. Never use a single wall

connector (stove pipe) in a mobile home installation. Use

only double-wall connector pipe, Dura-Vent DVL, Selkirk

metalbestos DS or Security DL double-wall connector or

any Listed double-wall connector pipe.

5.  In Canada, this appliance must be connected to a 6 inch

(152mm)  factory-built  chimney  conforming  to  CAN/ULC-

629M, STANDARD FOR FACTORY BUILT CHIMNEYS.

6.  Follow the chimney and chimney connector manufacturer’s

instructions when installing the flue system for use in a

mobile home.

7.  Maintain clearance to combustibles.
8.  Floor  protection  requirements  must  be  followed

precisely.

9.  Use  silicone  to  create  an  effective  vapor  barrier  at  the

location where the chimney or other component penetrates

to the exterior of the structure.

NOTE: 
•   Offsets from the vertical, not exceeding 45°, are allowed

per  Section  905(a)  of  the  Uniform  Mechanical  Code

(UMC).

•   Offsets greater than 45° are considered horizontal and are

also allowed, providing the horizontal run does not exceed

75% of the vertical height of the vent.

•   Construction, clearance and termination must be in com-

pliance with the UMC Table 9C. This installation must also

comply with NFPA 211.

NOTE: Top sections of chimney must be removable to allow

maximum clearance of 13.5 feet (411cm) from ground level

for transportation purposes.

Spark Arestor Cap 

Roof Flashing 

Storm Collar 

Joist Shield/Firestop 

Double wall 

connector pipe  

Floor Protector 

Outside Air Floor Vent 

Outside Air 

Rear Vent 

THE STRUCTURAL INTEGRITY OF THE MOBILE HOME

FLOOR, WALL AND CEILING/ROOF MUST BE MAINTAINED