Gardena R70Li ユーザーズマニュアル

28 - English 

The guide wire is a wire that is laid from the charging 
station towards, for instance, a remote part of the 
working area or through a narrow passage to be then 
connected with the boundary wire. The same cable 
roll is used for both the boundary and guide wires.

The guide wire is used by the robotic lawnmower to 
find its way back to the charging station but also to 
guide the robotic lawnmower to remote areas of the 
garden. 

To ensure an even cut over the entire lawn, the 
robotic lawnmower can follow the guide wire from the 
charging station to the guide wire connection in the 
boundary wire and start mowing there. Depending on 
the garden layout, one should adjust how often the 
robotic lawnmower is to follow the guide wire from the 
charging station. See 6.6 Settings on page 51.

The robotic lawnmower runs at varying distances 
from the guide wire to reduce the risk of tracks 
forming when the robotic lawnmower follows the 
guide wire to and from the charging station. The area 
beside the wire which the robotic lawnmower then 
uses is called the Corridor.

The robotic lawnmower always runs to the left of the 
guide wire as seen facing the charging station. Thus 
the corridor is to the left of the guide wire. The 
corridor is 50 cm wide. When installing, it is therefore 
important to have at least 75 cm free space to the left 
of the guide wire and at least 25 cm free space to the 
right of the guide wire, as seen facing the charging 
station. 

It is not allowed to lay the guide wire closer than 30 
cm from the boundary wire. 

The guide wire, as the boundary wire, can be stapled 
to or buried in the ground.

Maximum 
distance

At least 2m/7ft

At least 30 cm/12ft