Chicago Electric 42933 ユーザーズマニュアル

SKU 42933 

Page 14

The following checks, and possible adjust-

ments, should be done in the order listed 

before beginning operation.
WARnIng: For safety, unplug the line 

cord to the Radial Arm Saw.
Tables A (127), B (126), and C (125) 

1. 

are checked for straightness at the 

factory. 

However, changes in humidity can 

slightly alter the condition of the 

wood. With the Screw Clamps (131) 

tightened, use a straight edge or 

framing square to check for flatness 

and squareness. Sand down any high 

spots using fine sandpaper.
Check for Arm tightness on the Col-

2. 

umn (132). If loose, tighten Bolt (115).

3.  Check the crosscut travel of the Saw 

Blade for squareness. 

- Lock or tighten all adjustment levers 

and knobs. 

- Lower the Arm until it just clears the 

Table A front. 

- Place a framing square so it just 

touches a tooth of the Saw Blade. 

- Mark this location with a pencil on 

the table and draw a straight line us-

ing the square. 

- Check that the Saw blade follows 

this line from front to back. 

If the Saw Blade moves to the right 

or left side of the line as it travels the 

entire length of the Arm, loosen the 

Screw Clamps (137) and lightly tap 

on the Table left or right side until 

there is full travel alignment. Tighten 

the Screw Clamps again.

4.  Check that the Saw Blade is square 

to Table A. 

- Place a framing 

square on Table A 

so that the square 

is flat on the Saw 

Blade (not touching 

teeth). 

- If there is no gap between the 

square and the Saw Blade, no adjust-

ment is necessary. 

- If the square does not touch the 

Saw Blade evenly (with the square 

flat on the Table A), loosen the Bevel 

Lock Knob (71) and adjust the motor 

until the gap between Saw Blade and 

the square is eliminated.

5.  Check that the Saw Blade is square 

to the rip fence. 

- Firmly place a 

framing square 

against the rip 

fence and the blade 

as shown to the 

right. The square 

should not touch any teeth. 

- If the square is not flush with the 

entire blade, loosen the yoke 

pivot Clamp Handle (66) and move 

the motor assembly until any gaps 

have been eliminated. Tighten the 

Yoke Pivot Clamp and recheck align-

ment. (This will simultaneously set 

both yoke indexing positions for in 

and out ripping.)