Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
75
3
Type the Circuit Throughput in bits per second and press Enter. The IAD
prompts you to enter the Be.
4
Type the Be value in number of bits and press Enter. The IAD displays the
FR DLCI Options menu.
5
Press Escape to return to the Frame Relay DLCI Configuration menu and
continue.
Configure FRF.12
Fragmentation
To configure FRF.12 Fragmentation, follow the steps below.
1
Type “3” on the Frame Relay DLCI Options menu (Figure 4.41) to display
the End-to-End Fragmentation menu (Figure 4.42).
Figure 4.42
End-to-End Fragmentation Configuration Menu
2
Type “1” to select End-to-End FRF.12, or type “2” to manually set the
fragment size. If you type “1”, the IAD displays the status and prompts you
to enable or disable End-to-End FRF.12. If you type “2”, the IAD prompts
you to enter the maximum fragment size.
3
Type the fragment size in bytes and press Enter. The IAD displays the End-
to-End Fragmentation Configuration menu. Press Escape to return to the
DLCI Configuration menu.
Modify Existing DLCI To modify an Existing DLCI, follow the steps below.
1
On the Frame Relay DLCI Configuration menu, type “2” to select Modify
Existing DLCI.The IAD displays the port table and prompts you to select
the appropriate port as shown in
Figure 4.43
Modify Existing DLCI Menu
2
Type the port number corresponding to the DLCI you want to update and
press Enter.
3
Type the new DLCI number and press Enter. The IAD displays the Frame
Relay Encapsulation Configuration menu as shown in Figure 4.40.
4
Continue with the steps listed above under “Adding a new DLCI.”
Delete DLCI To delete a DLCI, follow the steps below.
1
On the Frame Relay DLCI Configuration menu, type “3” to select Delete
DLCI. The IAD displays the port table and prompts you to select a port.