Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
77
Figure 4.46
FRF.12 Configuration Menu
Each option on this menu is described in detail below.
Enable/Disable FRF.12
To enable or disable FRF.12, follow the steps below.
To enable or disable FRF.12, follow the steps below.
1
Type “1” on the Frame Relay FRF.12 Configuration menu. The IAD
displays FRF.12 Fragmentation status (enabled or disabled), and prompts
you to change it.
2
Type “E” to enable End-to-End fragmentation, or type “D” to disable it.
The IAD saves the configuration and displays the FRF.12 Configuration
menu. Press Escape to continue.
Enable Automatic Fragment Sizing
Type “2” on the Frame Relay FRF.12 Configuration menu to enable
Type “2” on the Frame Relay FRF.12 Configuration menu to enable
automatic fragment sizing. The IAD saves the configuration and displays the
FR FRF.12 Configuration menu. Press Escape to continue.
FR FRF.12 Configuration menu. Press Escape to continue.
Set Manual Fragment Size
To manually set the Fragment Size, follow the steps below.
To manually set the Fragment Size, follow the steps below.
1
Type “3” on the Frame Relay FRF.12 Configuration menu to manually set
fragment sizing. The IAD prompts you to enter the maximum fragment size.
2
Type the maximum fragment size in milliseconds or bytes and press Enter.
The IAD saves the configuration and displays the FR FRF.12 Configuration
menu. Press Escape to continue.
Configure
CopperMountain
Fragmentation
Configuration
Select Configure CopperMountain Fragmentation by typing “2” on the FR
Fragmentation Configuration menu to display the CopperMountain FR
FRF.12 Configuration menu (Figure 4.47).
FRF.12 Configuration menu (Figure 4.47).
NOTICE:
With CMCP enabled, the DSLAM controls fragmentation settings, and
IAD configuration is not required.
IAD configuration is not required.