Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch テクニカルリファレンス
9
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
371
Quality of Service
This chapter describes how to use the CLI to configure rate limits for the interfaces
and class-of-service processing for switch traffic. It includes the following
sections:
and class-of-service processing for switch traffic. It includes the following
sections:
•
•
Rate Limit Profile Commands
The rate-limiting feature enables you to set a maximum incoming traffic rate for a
port. When the data rate exceeds configured rate, the switch drops all further
traffic from the port. Rate limits are applied per port and per VLAN.
port. When the data rate exceeds configured rate, the switch drops all further
traffic from the port. Rate limits are applied per port and per VLAN.
To apply rate limits, you first use this page to create one or more rate limit profiles.
Profiles specify the criteria that determines when the rate limit is exceeded and,
optionally, identify the VLAN that it applies to. Then, you assign rate limit profiles to
interfaces.
Profiles specify the criteria that determines when the rate limit is exceeded and,
optionally, identify the VLAN that it applies to. Then, you assign rate limit profiles to
interfaces.
This section describes the commands you use to create rate limit profiles and
assign them to interfaces.
assign them to interfaces.
rate-limit profile (Global)
Use this command to create rate limit profile. If a VLAN ID is specified, then the rate
limit is for that VLAN only. The profile created with this command can be applied to
any interface separately at interface level.
limit is for that VLAN only. The profile created with this command can be applied to
any interface separately at interface level.
rate-limit profile profile-id cir cir-value cbs burst-size
[
vlan vlan-id
]