Wilson Electronics LLC 460005 ユーザーズマニュアル

ENGLISH

or feedback and reduces the 

effectiveness of the Connect 3G.

4.   If you do not know how to mount 

hardware or run coax cable through 

walls, ceilings and floors, get help from 

a weBoost Installer at www.weboost.

installernet.com or from a qualified 

contractor or electrician.

We recommend you install the Lightning 

Surge Protector 

(859992). Attach the 

cable from the Outside Omni Antenna to 

the surge protector and ground the surge 

protector. The LSP is sold separately (refer 

to page 11 for more info. 

For more detailed instructions on 

installation, read the description later in this 

guide or watch the video at weboost.com/

us/Connect3Gvideo.
NOTE: Create a “soft” install first by testing 

components in your proposed locations 

before securing them with hardware. 
1.    Select a location on the roof of the 

building to install the Outside Antenna. 

Make sure the antenna is clear of 

obstructions that could block the signal 

from the nearest cellular tower. 

2.   Select a location to install the Signal 

Booster that is well ventilated and 

away from excessive heat, moisture, 

and direct sunlight. 

3.   Select a location for the Inside 

Antenna that is in the center of the 

area where the signal needs to be 

amplified and a minimum of 20 vertical 

feet or 50 horizontal feet from the 

Outside Antenna.

Inside area needing increased signal 

Inside area needing increased signal 

4.   Run the coax cable from the Outside 

Antenna to the Signal Booster and 

attach it to the connector labeled 

“Outside Antenna.” Connect 

another coax cable to the connector 

labeled “Inside Antenna” and run it 

to the Inside Antenna. NOTE: Be 

careful not to bend the center pins 

on the connectors when securing 

connections. 

5.   Once you have ensured all 

connections are tight, connect the 

Signal Booster to a surge protected 

power strip with at least a 1000 Joule 

rating to protect your equipment from 

power surges and lightning strikes 

(refer to page 11 for information on 

lightning protection). 

6.   If your Connect 3G is working 

correctly, the lights will be green. If 

the lights are orange or red, see the 

“Troubleshooting” section starting on 

page 7.

1.   Select a location on the roof or an 

outside wall where the Outside 

Antenna can be mounted without 

obstruction (at least three feet of 

clearance in all directions) and with at 

least 20 feet of vertical or 50 feet of 

horizontal separation from the Internal 

Antenna.   

Inside area needing increased signal 

Inside area needing increased signal 

2.  

After connecting the coax cable to the 

antenna, run it underneath the down side 

of your roof’s flashing if mounted on the 

roof. Tip: Often you can follow the route 

used by satellite TV cables. If you attach 

the Outside Antenna to a wall, run the 

cable along the outside of the wall to the 

area where you want the cable to appear 

on the inside of the building, then drill a 

hole through the wall where the cable will 

enter the building. Caution: Before drilling 

holes for the cable, be sure there are no 

electrical outlets, wiring, or sewer or water 

pipes you could puncture or sever. 

3.   Seal any holes with silicone, cable 

bushings or other waterproof sealant.