Turbocomm Tech Inc. IA300 ユーザーズマニュアル
Model : IA-300
Installation Guide
Page 9
IP OVER ATM SERVICE FOR WINDOWS 98 2ND EDITION
NOTE: This section is for Windows 98 2
nd
Edition only.
1.
After installing the IA-300 card and restarting the system, the Add New Hardware
Wizard window will automatically appear and indicate that a new PCI Network
Controller has been found. Click Next.
Wizard window will automatically appear and indicate that a new PCI Network
Controller has been found. Click Next.
2.
Then select Search for the best driver for your device.(Recommended)., click
Next.
Next.
3.
Insert the CD labeled IA-300 Driver into your CD-ROM drive.
4.
Then select Specify a location and enter <CD drive letter>:\Drivers\Win98SE\IPoA
(e.g. D:\Drivers\Win98SE\IPoA) and click Next.
(e.g. D:\Drivers\Win98SE\IPoA) and click Next.
5.
The Add New Hardware Wizard will find the ITeX ADSL PCI NIC, click Next.
6.
When the Service Option window appears, click Next for the default installation
(VPI=0, VCI=35, Framing=LLC/SNAP). For Advanced settings, please consult your
ADSL service provider for detailed information.
(VPI=0, VCI=35, Framing=LLC/SNAP). For Advanced settings, please consult your
ADSL service provider for detailed information.
NOTE: If you clicked Advanced, the Service Options window shows the Connection
Address. Enter the service Connection Address, click OK. The previous Service
Option window will appear, click Next.
Address. Enter the service Connection Address, click OK. The previous Service
Option window will appear, click Next.
7.
Additional files are copied from the IA-300 disk to the hard drive. In addition, files are
now copied from the Windows CD (system CAB files) to the hard drive.
now copied from the Windows CD (system CAB files) to the hard drive.
8.
If prompted to insert the CD do so at this time then enter the <CD drive Letter>:
Win98 (e.g. D:\Win98) and click OK.
Win98 (e.g. D:\Win98) and click OK.
9.
At the conclusion of the IA-300 driver installation, click Finish.
10. For the PC system to properly set up the IA-300, a system Restart is required. Click
Yes.
11. After restarting the system, the Diagnostic Tools icon is active and monitoring
connectivity. The Diagnostic Tools – found on the task bar – with blinking (or solid)
Black or Green lights indicate a good connection. Diagnostic Tools with Red lights
indicate a connection error or driver load error. Verify that the cable is properly
connected to the data port of the service and Speed Touch PC card.
Black or Green lights indicate a good connection. Diagnostic Tools with Red lights
indicate a connection error or driver load error. Verify that the cable is properly
connected to the data port of the service and Speed Touch PC card.
---------------------------------------------------------------------------------------------------------------------
12. You must now make a network connection. From the Start menu on the tool bar,
select Settings, Control Panel , and then double click on the Network icon.
13. When the Network window appears select the Configuration tab, scroll the installed
network component window and select TCP/IP àATM Emulated LAN. Still in the
Network window, click on the Properties button. Select the Advanced tab, and
change the "Allow Binding to ATM" value to Yes. Click OK.
Network window, click on the Properties button. Select the Advanced tab, and
change the "Allow Binding to ATM" value to Yes. Click OK.
14. The Network window appears. Select the Configuration tab, scroll the installed
network component window and select ITeX ADSL PCI NIC, click Add .