Biolase Inc. EPIC ユーザーズマニュアル

22 |

P a g e

5 4 0 0 3 2 1 R e v . X : D R A F T

System Setup

 Place unit in a clean, dry and well-ventilated area.

 Verify power switch is in OFF position

 Connect power cord to power connector on the unit and plug into wall outlet to

charge the rechargeable battery. Before first use, it is recommended to fully
charge the battery (at least 2 hours). Once the battery is charged, unplug the
power cord from the wall outlet and the console. The unit will run on battery
power alone.

 Connect chosen fiber to the console

CAUTION:

Do not cover or block ventilation channels. These channels provide air-flow

path to cool unit.

CAUTION:

Do not bend fiber optic cable sharply or fiber will break.

 Remove protective tip and handpiece from fiber shaft (See Fig. 14)

 Verify visually that protective window is clean. If not – blow off any residue or dirt

with compressed air. For better results, use a non-linting cotton swab soaked
with alcohol.

 Carefully connect the Handpiece (See Figure 13)

 Insert the selected tip and tighten it clockwise until snug.

 Wind excess fiber optic cable onto the fiber spool around the base of the

console.

 Place handpiece in handpiece holder. (See Figure 12)

 If using the classical “feed-through” fiber handpiece, make sure the fiber

connector is free of dirt and dust. If not – clean with a cotton swab soaked with
alcohol.

WARNING:

Never point fiber optic at eyes.

WARNING:

Never operate the laser without a fiber tip attached.

WARNING:

All persons present in the operatory must wear protective eyewear when
laser is in operation.

Operation

Turn On the EPIC 10

 Ensure that the battery has enough charge for operation, or connect power cord

to power connector on the unit and plug into wall outlet.

 Turn power switch at the rear of the base of the console to ON position. The

EPIC 10

Welcome screen will be displayed.