ABUS AZ4111 ユーザーズマニュアル

 

 

8

UK 

If you want to monitor only part of your object – e.g., only 
the contacts of your windows or the ground floor – you 
can activate the alarm system internally. 
In the alarm centre’s program mode, you can define zones 
not to be monitored by internal activation. To activate 
internal mode B, C or D:

 

 
Enter a valid user code: 

and then press: 

, 

 

or 

. Depending on programming, the different zones 

are now activated. 

 

 
 
 
 
 
The alarm centre has now started the exit delay time so 
that you can leave the area. The delay time is now 
counted down in seconds. A constant signal tone is 
generated for the duration of the delay time. 

 

The remaining sequence of events is as for activating the 
complete alarm system. 
 
IMPORTANT: Immediate activation of internal areas can 

also be programmed – i.e., without a delay 
time. In that case, there is no constant tone 
and the system acknowledges successful 
activation of the area. 

 

With a key switch, you can activate or deactivate your 
alarm system with a key instead of a user code. It is also 
possible to activate via the control unit and deactivate 
using a key switch, or vice versa. 
 
The alarm system can also be activated in different areas 
with a key switch, depending on how the zone is 
programmed. Also, only the area programmed for a key 
switch can be deactivated. An alarm can be stopped 
immediately at any time. 

 

 
TIP: 
The use of key switches is particularly useful in the 
commercial area. In particular, where there are many 
different users, or the risk of passing on the user code to 
unauthorised persons is to be avoided.