Reely 1:7 RC model car Nitro Buggy GSC8020AENGBL データシート

Step 1:
Remove the safety clips on the left and right of the vehicle, see 

arrows  in  the  figure  on  the  right  (figure  shows  left  side  of  the

vehicle).
Step 2:
Pull out the long safety pin right behind the front axis (below the 

car body, close to the steering mechanics).
Step 3:
Remove the two black, L-shaped plastic brackets above the ve-

hicle front.
Step 4:
Remove the car body front.
Then fold back the entire rear (with overroll bracket and car bo-

dy).
Observe that the grip for the rope pull starter is guided through 

the car body opening so that it cannot catch at the car body.

For assembly of the vehicle, proceed in reverse order. 

The rear spoiler is delivered separately from the vehicle. Fasten 

it to the vehicle with the enclosed assembly set. 
The nuts are pushed into small openings below the rear spoiler 

holder. Then put the rear spoiler on the rear spoiler holder.
Push the screw through the washer and the plastic holder and 

fasten the rear spoiler to the vehicle.

Æ

Æ