Reely 1:7 RC model car Nitro Buggy GSC8020AENGBL データシート

The air filter (a foam ring) at the carburettor of the vehicle must

be oiled with suitable air filter oil before commissioning of the

vehicle.
The oil in the air filter ensures that finest dust particles stick to the

oil and do not get into the motor. 
These fine dust particles increase wear at the pistons and cylin-

der wall and reduce output. At continuous motor operation wi-

thout oiled air filter, permanent motor damage may occur; loss of

warranty/guarantee!
Check the air filter for correct oiling before every run. Oil it with

a special air filter oil (not included in the delivery, available as an

accessory) only. Never drive without an oiled air filter!
For oiling, push the air filter (only the foam ring) into a small plastic bag and add a few drops of air filter oil. Close the

plastic bag and compress the air filter several times so that the air filter oil moistens the entire air filter.
Wash the air filter from time to time (depending on dust load when driving after each drive if necessary) with benzene

or replace it with a new one.

Open the transmitter’s battery/rechargeable battery compartment and insert batteries or fully charged rechargeable 

batteries. Observe correct polarity (plus/+ and minus/-), see label on the battery/rechargeable battery compartment. 

Close the battery/rechargeable battery compartment of the transmitter again.
Switch on the transmitter. Check the function of the transmitter.

  Observe the enclosed operating instructions for the remote control system.

Switch on the receiver system of the vehicle. The switch is at the side of the receiver box.

In order not to lose control over your model you should, before every first start or after a crash, check the function and

range of the RC system. For the range test, it is sufficient to check the steering servo function.
Due to the good traction of the wheels and the weight of the vehicle, the wheels would not follow your steering com-

mands spontaneously and directly while still on the floor. Therefore, support the model at the front axle in a way that

allows the wheels to hang freely.

  Only perform the range test without the engine running!

Æ