Electrolux E32AR85PQS オーナーマニュアル

7

1.  Remove handle from carton and any 

other protective packaging.

2.  Position handle end caps over upper 

and lower preinstalled shoulder bolts 

(A) that are fastened into door.

3.  While holding handle firmly against 

door, fasten upper and lower Allen set 

screws (B) with supplied Allen wrench.

NOTE

All set screws should be tightened so the 

screw is below the surface of the handle. 

The handles should be drawn tight to 

freezer and refrigerator doors with no gaps. 

Opening the opposite door while tightening 

the Allen screw makes installation easier.
The door handle may loosen over time or if 

it was installed improperly. If this happens, 

tighten the set screws on the handles.

To remove the toe grille, use a Phillips 

head screwdriver and remove the 2 

screws holding the toe grille to the cabinet. 

Then pull the toe grille away from the unit.

•  The refrigerator must have all bottom 

corners resting firmly on a solid floor.

•  The floor must be strong enough to 

support a fully loaded refrigerator.

•  It is 

VERY IMPORTANT for your 

refrigerator to be level in order to 

function properly. If the refrigerator 

is not leveled during installation, 

the door may be misaligned and 

not close or seal properly, causing 

cooling, frost or moisture problems.

Remove 

Screws

Toe Grille